Belkin ADSL Modem with Wireless 802.11g Router Provozní pokyny Strana 117

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 204
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 116
DG834G Reference Manual
Virtual Private Networking 8-7
v3.0, September 2005
“Step 1: Configuring the Client-to-Gateway VPN Tunnel on the DG834G” on page -7 uses the
VPN Wizard to configure the VPN tunnel between the remote PC and network gateway.
“Step 2: Configuring the NETGEAR ProSafe VPN Client on the Remote PC” on page -12
configures the NETGEAR ProSafe VPN Client endpoint.
Step 1: Configuring the Client-to-Gateway VPN Tunnel on the
DG834G
The worksheet below identifies the parameters used in the following procedure. A blank
worksheet is at “Planning a VPN” on page 8-3.
Note: This section uses the VPN Wizard to set up the VPN tunnel using the VPNC
default parameters listed in Table 8-2 on page 8-5. If you have special requirements
not covered by these VPNC-recommended parameters, refer to “How to Set Up
VPN Tunnels in Special Circumstances” on page 8-35 to set up the VPN tunnel.
Zobrazit stránku 116
1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 203 204

Komentáře k této Příručce

Žádné komentáře